IMPORTANT: It is necessary to carry out these steps at the installation site, even if this Niō was previously added to this Company elsewhere. The GPS coordinates of the Niō are automatically captured during these steps and used for critical services, such as 911 dispatch. A Niō previously associated with a different company must first be deleted before it is set up again.
STEP 0
Before You Begin
Please have the following information handy, depending on your role. To add a Niō to a Company, you must be an Administrator or a Manager.
Required Information
- Serial Number of Niō
Only needed if other Niōs are nearby - Name for Niō
Easily changed later - Wi-Fi Network Name
If using Ethernet, Wi-Fi not needed - Wi-Fi Password
If using Ethernet, Wi-Fi not needed
Required by Security Agency Administrator/Manager Only
- Company
- Sector of Company
Default if one was not assigned
STEP 1
Locate the Niō Using the iDter App
Stand close to the Niō and make sure the LED is flashing red. In the iDter app, open the Niō and Settings tab and tap the “+” button in the upper righthand corner. The app will start searching for Niōs nearby.
Security Agency Administrator/Manager | Company Administrator/Manager |
|
|
STEP 2
Begin Pairing
Any Niōs in range will appear in a list, with the serial numbers listed. Select the one you’d like to add. The Niō will confirm the pairing process has started by saying, “System Initializing.”
Security Agency Administrator/Manager |
Company Administrator/Manager |
|
|
STEP 3
Enter Niō Information
Enter a name for the Niō (the name can be changed later) and tap Set Up Location. This will automatically determine the camera’s location. Each Niō must be assigned to a specific Company. Companies may be grouped into Sectors, maybe all in a Default Sector.
Company Administrator/Manager
The Niō has already been set up with the correct company and agency. Skip to Step 4.
Security Agency Administrator/Manager Only
STEP 3a
|
STEP 3b
|
|
|
STEP 4
Select Internet Connection
ETHERNET: We strongly recommend using Ethernet rather than Wi-Fi. Please make sure Use Ethernet Connection is toggled on. This will make the Wi-Fi setup flow disappear.
Wi-Fi: If you are not using Ethernet, please toggle off the Use Ethernet Connection button. Select a network from the list and enter its password. When it connects, the Niō will say, “Connected to Wireless Network.” The LED will turn from green to blue.
Security Agency Administrator/Manager |
Company Administrator/Manager |
|
|
STEP 5
Confirm: Add Niō
Once the information has been entered, select Connect Niō and wait for the confirmation message. This Niō is now associated with the right Company! Once connected, the LED at the bottom of the unit will glow green.
Security Agency Administrator/Manager |
Company Administrator/Manager |
|
|
Comments
0 comments
Please sign in to leave a comment.