STEP 1
Parts

You will need the following items along with a Phillips head screwdriver:

STEP 2
Screws

Locate the two screws on the right side of the unit and unscrew them.

NOTE: They are captive and will not completely remove.

STEP 3
Remove Cover

Open the cover (Opens Right To left) with hinges on your left, you will see a silver box cover below the power supply. Remove the 3 screws seen in this picture.

STEP 4
Wires

Proceed to connect the power cord matching the proper (power, neutral, and ground) wires. To secure wires, press down on each tab (N, ⏚, and L) while inserting the wire. Release tab to secure wire.

STEP 5
Mount Camera or Power On

Once complete, if for testing purposes, you may power on camera by plugging in the cord to power. If this is a permanent installation, you may route the power cord where needed and proceed with mounting.